Siemens SITRANS TK Bedienungsanleitung Seite 52

7NG3120, 7NG3121, 7NG3122
4 Operation
4.1 Operation with a PC/Laptop
4.1.1 Operation with a PC/laptop when using SITRANS TK
When using the SIPROM TK parameterisation software and the modem for
SITRANS TK, the transmitter can be operated with a PC. To do this, simply con-
nect the transmitter to the PC via the modem. In doing so, the power needed for
the transmitter is supplied through the PC's serial interface. For further details,
please refer to the SIPROM TK instruction manual and, for details of the modem,
refer to the SITRANS TK instruction manual.
4.1.2 Operation with a PC/laptop when using SITRANS TK-H
When using the SIMATIC PDM parameterisation software and the interface for the
transmitter can be operated and parameterised with a PC. To do this, the interface
must be connected to the output circuit. To this end, the transmitter's power supply
must be in operation and the load in the circuit must be at least 230 Ohm.
4.2 Operation with a hand-held communicator
Connect the hand-held communicator to the SITRANS TK-H (see Figure 7).
Action keys
With the key, you switch the hand-held communicator on and off. After
switching on, the hand-held communicator automatically assumes communication
with the transmitter. The online menu appears in the display.
With the key, you move the cursor up through the menu bar. The selected
line of the menu is marked.
With the key, you move the cursor down through the menu bar. The selected
line of the menu is marked.
With the key, you move the cursor to the right through the menu bar or you
branch to a subroutine. The name of the selected subroutine is shown on the top
edge of the display.
52
Instruction Manual
SITRANS TK/TK-H
C79000-B7174-C12-07