Bosch BHNL Serie Gebrauchsanleitung Seite 49

en
Congratulations on your purchase of a Bosch vacuum
cleaner from the BHN series.
This instruction manual describes various BHN models,
which means that some of the equipment features and
functions described may not apply to your model. You
should only use genuine Bosch accessories, which
have been specially developed for your vacuum cleaner
to achieve the best possible vacuuming results.
Charging
!
Caution:
Before using the vacuum cleaner for the first time,
fully charge the batteries.
To charge the appliance, only use the charging cable
included with the appliance. The charging cable
must only be connected and operated as specified
on the rating plate. Do not charge the appliance at
temperatures below 0 °C or above 40 °C.
1
Fig.
‡
Plug the charging cable into the connection at the
rear of the appliance.
‡
Plug the charging cable plug into the socket.
‡
The charging indicator is flashing slowly in white
when the appliance is charging.
‡
Once the battery is fully charged, the charging indi-
cator lights up white and goes out after a few minu-
tes. The battery will stop charging. Disconnect the
appliance from the mains briefly to check. The indi-
cator will then light up white again.
‡
It is safe to leave the appliance connected to the
charging cable and socket even when it is fully char-
ged.
‡
It is normal for the charging cable and hand stick to
become hot and this is not a cause for concern.
Battery state indicator
Operating status
Normal mode
Battery capacity below
20%
Battery flat
Charging
Battery is fully charged
Over-/undertemperature
protection
LED indicator
White LED lit
White LED flashing slow-
ly
LED off
White LED flashing slow-
ly
White LED remains lit
continuously for 2 minu-
tes, then goes out
Red LED remains
continuously for 10 se-
conds, then goes out
Vacuuming
2
Fig.
Slide the sliding switch to the required
position to set the suction power:
‡
Position 1
For simple cleaning tasks
The appliance achieves the maximum run time at
this setting.
‡
Position 2
Maximum suction power
For especially demanding cleaning tasks.
The appliance achieves a shorter run time at this set-
ting.
Crevice nozzle
For vacuuming crevices and corners, etc.
3
Fig.
‡
Insert the crevice nozzle into the air intake opening
of the cordless vacuum cleaner as shown.
After using the appliance
4
Fig.
‡
Switch off the appliance after vacuuming.
Emptying the dust container
In order to achieve the best possible vacuuming re-
sults, the dust container should be emptied after every
use.
5
Fig.
‡
Press the release button to unlock the dust contai-
ner and then remove it from the motor unit.
6
Fig.
‡
Use the handle to remove the motor protection filter
and foam filter from the dust container.
‡
Empty the dust container.
Cleaning the filter
7
Fig.
‡
Unlock the dust container. Remove the motor pro-
tection filter and foam filter from the dust container
5
(see fig.
‡
Clean the motor protection filter and foam filter by
tapping out the dirt.
‡
If the filters and the dust container are heavily
soiled, the dirt can be washed out.
lit
Then wipe out the dust container with a dry cloth; al-
low the filters to dry completely before re-inserting
them.
6
and )
1
2
49