EuroLite LED TIO-1 Bar Bedienungsanleitung Seite 18

When actuating a button, always hold the remote control in the direction of the sensor. There must be visual
connection between the remote control and the sensor.
If the range of the remote control decreases (7 meters as a maximum), replace the
battery. For this purpose, on the rear side of the remote control press the small bar
with the groove to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive
pole of the button cell shows upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type. Please dispose of
old and used batteries properly. Batteries are hazardous waste and should not be disposed of with regular
Switching the LEDs on and off
The LEDs can be switched on with the button ON and switched off with the button OFF. However, the control
unit remains switched on.
Wash-Effect
RGB+W: Static light with 4 shades each plus white (16 static colors in total)
Flash: 3 color switch: red – green - blue
Strobe: 3 color fade: red – green - blue
Fade: 7 color fade: red – yellow - green - cyan – blue – magenta - white
Smooth: 7 color switch: red – yellow - green - cyan – blue – magenta - white
:
:
:
:
domestic waste!
+
Brightness
OFF OFF OFF OFF
R R R R G G G G B B B B
Sound Auto Strobe
In static color mode, brightness up
In switch or fade mode, color change speed increases
In static color mode, brightness down
In switch or fade mode, color change speed decreases
CAUTION!
-
Brightness
OFF
IRC-2 IRC-2 IRC-2 IRC-2
ON
ON ON ON ON
16 static colors
W W W W
3 color switch
FLASH FLASH
3 color fade
STROBE STROBE
7 color fade
FADE FADE
7 color switch
SMOOTH SMOOTH
OFF
Flower effect control
18/20 00069679.DOC, Version 1.0