urmet 1099/214B Schnellanleitung Seite 11

2 SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, URMET S.p.A. declares that the radio equipment type: camera 1099/214B and
1099/216B is in compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: www.urmet.com.
3 INSTALLATION
It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure. Fit the aerial
on the camera. It is advisable to install and configure one camera at a time if you are
installing multiple cameras on the same network.
2. Connect the camera to the network (see section 4). It is advisable to check that the WiFi
signal received by the camera is higher than or equal to 60.
3. Position the camera in a point on the wall or other surface and adjust the bracket to frame
the required scene. In the case of an AF camera model, make sure that the frame and the
zoom level is correct. Adjust the bracket again and lock it in its final position
4. If you want the camera to record and store video files on a micro SD card (not included),
plug the card into the slot when the camera is powered off (see the picture below). Power
on the camera and use the camera's wepgabe or the app to format the card before starting
the recording function.
5.
If you are using a NVR/HVR device, assign a static IP address to the camera and use the NVR/HVR
menu to add the camera to a recording channel.
4 HOW TO CONFIGURE THE CAMERA IN A NETWORK
In this section explanation is provided to configure the camera in the network and to connect it
remotely from the smartphone App or from a PC.
IMPORTANT NOTE: the camera is provided with two different network boards, one for the wire
connection and one for the WiFi connection, each with its own MAC address and is own IP
address.
1099/214B 1099/216B
11