Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Press the [Z/T] key to tare the scale. The weight that was displayed is
stored as the tare value and that value is subtracted from the display,
leaving zero on the display. The "NET indicator will be ON. As a product
is added only the net weight of the product will be shown. The scale
could be tared a second time if another type of product was to be
added to the first one. Again only the weight that is added after taring
will be displayed.
• When the container is removed a negative value will be shown. If the
scale was tared just before removing the container this value is the
gross weight of the container plus all products that was removed. The
"ZERO" indicator will be on to indicate that the platform is back to the
same condition as it was when zero was last set.
• To delete a Tare value, press [Z/T] when the pan is empty.
6.3
WEIGHING A SAMPLE
To determine the weight of a sample, first tare the empty container if it is to be used
and then place the sample in the container. The display will show the net weight of
the sample and the units of weight currently in use.
© Adam Equipment Company 2010
Werbung
