Herunterladen Diese Seite drucken

cecotec BOLERO AGUAZERO 4201 E Bedienungsanleitung Seite 88

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 131
ENGLISH
To remove the filter assembly, pull the handle of the container upwards.
-
The filter assembly should be cleaned once a week.
-
To clean the coarse filter and the microfilter, use a soft cleaning brush.
-
Then, reassemble the filter parts as shown in the previous figures and put the whole
-
assembly back into the dishwasher.
Put the filter assembly in place and press down. Never use the dishwasher without the
-
filters installed.
Incorrect substitution of the filter may reduce the performance level of the device and
-
damage the tableware and utensils.
WARNING!
Never use the dishwasher without the filters installed. When cleaning the filters, do not knock
them. Otherwise, the performance of the dishwasher may be deformed and degraded.
Cleaning the spray arms
The arms accumulate chemical products, so it is necessary to clean the spray arms regularly,
as the chemicals in the hard water clog the spray arm jets and bearings. To remove the spray
arms, unscrew the nut clockwise to remove the washer on the top of the spray arm and
remove the arm. Wash the arms in soapy and warm water and use a soft brush to clean the
jets. Replace them after rinsing thoroughly (Fig. 21).
Care of the dishwasher
-
To clean the control panel, use a slightly damp cloth and then dry it thoroughly.
To clean the exterior, you can use a polishing wax specifically for household appliances.
-
Never use sharp objects, scouring pads or aggressive cleaners on any part of the
dishwasher.
Protection against freezing
If you leave your dishwasher in a cold place during the winter, where the temperature can
-
drop below 0 °C, we advise you to act as follows:
Turn off the electrical power to the dishwasher from the power supply.
-
Turn off the water supply and disconnect the water inlet tube from the dishwasher water
-
valve.
Drain the water from the inlet tube and water valve (use a container to catch the water).
-
Reconnect the inlet tube to the water valve.
-
Remove the filter from the bottom of the dishwasher and use a sponge to absorb the
-
water on the drain.
Cleaning the door
To clean the edge around the door, just use a soft, warm, damp cloth. To avoid water
-
from entering the door gasket and the electric components, do not use any type of spray
BOLERO AGUAZERO 4201 E _4201 INOX E
88

Werbung

loading

Diese Anleitung auch für:

Bolero aguazero 4201 inox e