cecotec Cumbia POWER ESPRESSO 20 PECAN Bedienungsanleitung Seite 42

ENGLISH
3. Pour hot water into the cup and allow it to heat up. After that, empty the cup and dry it.
Finally, put the hot cup on the drip grid.
4. After that, the coffee indicator light will light up; if it switches off, wait a few seconds.
When the indicator light remains steady, press the coffee button. Pres the coffee button
again when you have obtained the desired amount of coffee, the water pump will stop
working.
WARNING: do not leave the machine unattended during preparation, as it may be necessary
to handle the machine manually.
- When you have finished brewing coffee, remove the portafilter from the machine by
turning it to the left and then, remove the coffee residue from the filter by pressing the
filter holder lever.
- Let the coffee machine cool down completely and rinse the removable parts under the
tap.
- The brewing time for a single coffee is a maximum of 60 seconds. The water pump will
stop running if the running time exceeds 60 seconds. The brewing time can be adjusted
by following the steps below. Press and hold the coffee button for 3 seconds in standby
mode, the coffee indicator light will flash. Press the coffee button again within 5 seconds
to start the water pump. Press the coffee button again so that the water pump stops
operating. The configuration is then complete. The adjustable brewing time ranges from
15 to 60 seconds.
Preparing hot water
- Once the preheating process is completed, the power indicator light will stop flashing
and will remain steady. Then, press the coffee button, the water pump will start pumping
water. Turn the steam knob to the steam/hot water position so that hot water comes out
from the steam wand. To stop hot water preparation, press the coffee button again. The
hot water function is used to heat the cup, prepare tea or to cool the machine.
- Refer to the "Preparing an espresso" section when you need to adjust the hot water
brewing time.
Preparing a cappuccino
To prepare a cappuccino, fill the espresso cup with frothed milk.
Method
1. To prepare a cappuccino, first prepare an espresso following the steps in the section
"Preparing an espresso". Make sure the steam knob is in the off position.
2. Press the steam button, the coffee indicator light will light up. Then, wait until the steam
indicator light also lights up.
Note: during the preheating process, the steam indicator light will turn on and off to maintain
the desired temperature.
42