Werbung
Emptying of the water tank
•
As soon as the water tank is full, the "WF" blinks on the display, the standby mode automatically turns
on, it will sound the warning alarm and all the buttons will be locked until the tank is emptied.
•
Turn off the power and unplug the power cord. To empty of the water tank you need to remove the
rubber stopper on the bottom of the unit and let the water leak into a container. Once you reboot the
device, it will work normally.
•
Continuous drainage (only in dehumidifying mode): Remove the rubber stopper on the bottom of the
unit and connect the drainage hose to the opening. Let the water leak into a container (pic.5).
Cleaning
Always disconnect the appliance from the power outlet and let it cool
•
before cleaning. Never immerse the appliance in water to prevent
electric shocks.
Wipe over the exterior of the appliance with a soft wet cloth and
•
neutral detergent and then wipe dry with a dry cloth.
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks. Clean the dust filter with
•
neutral detergent and about 40°C water. Rinse off any detergent,
then let it air-dry before inserting it back into the unit (pic.6).
If you do not use the unit for a longer time, empty the water tank
•
completely. Make sure that the unit is disconnected from the power
supply and that it is clean. Keep the unit covered in a dry place.
Troubleshooting
Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
3. Unit is too loud.
Pic.5
Possible causes
Water tank is full and indicating light
"W.F." is blinking.
Room temperature is lower than the set
temperature during operation mode
cooling.
The ambient temperature is too low or
too high.
In dehumidification mode, the ambient
temperature is too low.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Set temperature is too high.
Air inlet is blocked.
The ground is not even and flat enough
The sound comes from the flowing of
the refrigerant inside the unit.
Suggestions
Empty the water tank.
Reset the temperature.
We recommend the operaiton at 17-35°C.
The ambient temperature needs to be
higher than 17°C.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Reset the temperature.
Clean the air inlet
Place the unit on an even and flat surface.
None, this sound is normal.
Pic.6
Werbung
