Settings; Ringtone Type Settings; Default Outdoor Station Settings; Programming The Auxiliary Buttons - ABB Serie M22001 Handbuch

ABB-Welcome
4.2

Settings

4.2.1

Ringtone type settings

Pos : 21 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/83220-AP- xxx/Bedi enelemente - 83220- AP- xxx @ 18\mod_1303212853605_15.doc x @ 103673 @ @ 1
1. Hold "
blue LED & red LED flashing simultaneously).
2. Press to set the next ringtone type for the door bell.
3. Press
4. Press to set the next ringtone type for an intercom call from other apartments
or the guard unit.
5. Hold "
exit the system setting mode..
4.2.2

Default outdoor station settings

Pos : 21 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/83220-AP- xxx/Bedi enelemente - 83220- AP- xxx @ 18\mod_1303212853605_15.doc x @ 103673 @ @ 1
1. Pickup the handset, hold
station setting mode.
2. Press button to set the address of the default outdoor station. (the value is
indicated by the flash times of the red LED; it can be set from 1 to 9, defau lt
setting: 1).
3. Hold for about 3 seconds or put down the handset to save the setting and
exit the settings mode.
4.2.3

Programming the auxiliary buttons

Pos : 21 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/83220-AP- xxx/Bedi enelemente - 83220- AP- xxx @ 18\mod_1303212853605_15.doc x @ 103673 @ @ 1
Each programmable button is available only after setting. These buttons can be
set for different functions, e.g. call guard unit, intercom call or controls switch
actuator.
1. Enter the programming mode
Hold the programmable button for 3 seconds in the standby mode to enter the
programming mode.
2. Set the function for each programmable button
Check the needed function, and press
code which is indicated by the flash times of the blue LED.
● The function code can be changed: 0->1->2->3->4->5->0.
|
+ " for about 3 seconds to enter the system setting mode (with
to set the next ringtone type for a call from an outdoor station.
+ " for about 3 seconds to save the selected ringtone type and
for about 3 seconds to enter the default outdoor
to program the corresponding function
Operations
— 7 —