Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INTRODUCTION
Thank you for deciding to purchase the Solo Bedstick from Aidapt. The Bedstick is
manufactured from the finest materials and components available, when used correctly it is
designed to give many years of reliable trouble-free service. The Solo Bedstick is width
adjustable to suit single, double, queen and king size beds. The Solo Bedstick is not designed
to prevent users falling from their bed.
N.B. This equipment must be installed by a competent person and a risk assessment
undertaken as to the suitability of the bed stick for the particular user and user's bed.
Assessors should read and understand the MHRA publication; Bedrails: management
and safe use, which can be downloaded from www.gov.uk.
127 kg (20 st.) weight limit.
Do not exceed the weight limit stated – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives or other sharp instruments
•
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
•
do not use your product as it may compromise your safety, but contact your
supplier for support.
ASSEMBLY AND INSTALLATION
1.
Your Bedstick is shipped assembled in its closed position with one side of the stick
pointing downwards (See figure 1).
2.
Remove the two tube lock clips (see figure 2) and separate the Bedstick into two
parts.
3.
Rotate the inverted Bedstick section so that both looped handles are upright (see
figure 3).
4.
Remove the mattress from the bed where the Bedstick is to be installed and check
for any obstructions.
5.
Place the Bedstick onto the base of the bed, traversing the width.
6.
Adjust the width of the Bedstick so that both handles are parallel with the side of
the bed base.
7.
Re-insert the tube locks into the pre-punched holes, ensuring that the clip passes
completely through the tube frame and out the other side and is located into the
pre-punched adjustable extension piece (see figure 4).
8.
Check that the unit is properly adjusted by pulling the Bedstick in an outward
movement. If there is just a small degree of movement (up to 4 mm) then the
Bedstick is ready for the completion of the installation.
9.
Move the Bedstick up and down the bed to find the best position for the user to
safely lift themselves.
Fixing and Maintenance Instructions
2
Ver.7 10/2013 (1693)
Werbung
