Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INTRODUCTION
Thank you for deciding to purchase the Shower Chair from Aidapt. When used correctly it is
designed to give many years of reliable trouble-free service.
NB. This equipment must be installed by a competent person.
120 kg (18 3/4 stone) weight limit.
Do not exceed the weight limit stated – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives or other sharp instruments
•
as this may damage the product.
Check the product for any visible damage. If you see any damage or suspect a fault,
•
do not use your product, but contact your supplier immediately for support.
PARTS LIST
NO.
DESCRIPTION
7
Seat Board
6
Spring Pin
5
Vaulted Washer
4
Screw
3
Telescopic Tube
2
Lower Tube
1
Upper Tube
ASSEMBLY PROCEDURE
1.
Join the Upper an d Lower Tubes as shown in Fig. 1.
2.
Lay the seat upside down and put the joined Upper and Lower Tubes into the slot
of the seat ensuring that marks correspond as per Fig. 2, then tighten all screws.
3.
Turn the assembled Shower Stool the right way up on a flat surface. Equally adjust
each of the legs to the same height/number setting as per Fig. 3. Remember to
check the spring pins after use.
NB. We do not recommend the use of a battery operated screw driver when assembling
this product.
Usage and Maintenance Instructions
SPECIFICATION
Ø 8
Ø 6
M6x35
2
QTY
1
4
5
5
4
1
1
Ver. 1 04/2013 (2613)
Werbung
Inhaltsverzeichnis
