Dell Latitude 9440 2-in-1 Servicehandbuch Seite 17

About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
Steps
1. Using a plastic scribe pry open the solid-state drive shielding cover from the recess at the right side of the solid-state drive
shielding cover.
2. Remove the single (M1.2x1.5) screw that secures the solid-state drive to the system board.
3. Slide and remove the solid-state drive from the solid-state drive slot on the system board.
Entfernen und Einbauen von Komponenten 17