cecotec READYWARM 2050 MAX DUAL Bedienungsanleitung Seite 17

ENGLISH
Thermostat regulation
Once the room has reached the desired temperature, turn the thermostat knob (if included)
anticlockwise to the point where the appliance switches off. The thermostat will automatically
regulate and keep a constant set temperature.
Protection against overheating
The heater is equipped with a safety device that will switch off the heater in case of accidental
overheating (e.g., in case of blockage of the air inlet and outlet grilles, if the motor rotates
slowly or not at all). To reset it, disconnect the power plug for a few minutes, eliminate the
cause of the overheating and plug the appliance back.
4. CLEANING AND MAINTENANCE
Always disconnect the plug from the mains supply before cleaning the appliance.
Clean the air inlet and outlet grilles frequently.
Never use abrasive powders or solvents.
WARNING! Some parts of this product may become very hot and cause burns. You must take
special care with children and vulnerable persons.
5. TECHNICAL SPECIFICATIONS
Product reference: 08283
Product: ReadyWarm 2050 Max Dual White
Voltage: 220-240 V, 50 Hz
Power: 1000 W / 2000 W
Size: W125xD240 x H235 mm
Weight: 1.05 kg
Cord length: 1,4 m
Name of the model: 08283_ReadyWarm 2050 Max Dual White
Product Symbol Value
Heating power
32
READYWARM 2050 MAX DUAL
Unit Product Unit
Type of heat input, for electrical
storage.
Local heaters only (select one)
Rated heat output P 1.8 - 2.0
nom
Minimum heat
output P 0.90
min
(illustrative)
Heating power
maximum P 2.0
max,c
constant
Auxiliary energy
consumption
At rated heat
el N/A
output
max
At minimum heat
el N/A
output
min
In standby mode el 0.00
SB
ENGLISH
manual control of the
kW heating load, with [NO]
integrated thermostat
manual control of the
heat load with feedback
kW [NO]
of ambient and/or
outdoor temperature
electronic heat load
control with feedback
kW [NO]
of ambient and/or
outdoor temperature
Fan assisted heat
[NO]
output
Type of heat output/ambient
kW
temperature control (select one)
single-stage heat
kW output and no ambient [NO]
temperature control
Two or more manual
kW
stages, no room [NO]
temperature control
with mechanical
thermostat for room [YES]
temperature control
with electronic room
[NO]
temperature control
electronic room
temperature control [NO]
and daily timer
electronic room
temperature control [NO]
and weekly timer
Other control options (multiple
selection possible)
ambient temperature
control, with presence [NO]
detection
room temperature
monitoring, with open [NO]
window detection
with distance control
[NO]
option
READYWARM 2050 MAX DUAL
33