Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STORAGE TIME
Less than 1 month
1 to 2 months
2 months to 1 year
1 year or more
*Use petrol conditioners that have been formulated to extend shelf life.
PROBLEM SOLVING
Symptom
When the engine
Is there fuel in the tank?
does not want to
to boot:
Is there oil in the tank?
Is there a spark coming
out of the spark plug?
Does the fuel reach the
carburettor?
If the engine still does not start, take the generator
to an authorised generator service.
Lack of electricity
Is the AC circuit breaker
switched on?
in
AC sockets
The equipment connected
to the generator is faulty
If the generator still does not show voltage at the
AC outlets, contact your dealer or service centre
Lack of electricity
Is the DC circuit
protection switch on
in
The equipment connected
DC sockets
to the generator is faulty
If the generator still does not show voltage at the
DC sockets, contact your dealer or service centre
KIT CONTENTS:
• Unit 1 pc.
• Rechargeable battery 1 pc.
• Battery holder set 1 kpl.
• Transport wheels, axles nuts, washers 2 kpl.
• Transport handles 2 pcs.
• Shock absorbers 2 pcs.
• 230V / 16A plugs 2 pcs.
• Tool kit 1 kpl.
Rated data
Parameter
Engine capacity
Output voltage
Output frequency
Output power
RECOMMENDED SERVICE
PROCEDURE
TO PREVENT HARD STARTING
No preparation required.
Fill with fresh petrol and add petrol
conditioner.
Fill with fresh petrol and add petrol
conditioner.
Drain the float bowl of the carburettor.
Empty the fuel sediment reservoir.
Fill with fresh petrol and add petrol
conditioner.
Drain the float bowl of the carburettor.
Empty the fuel deposit tank.
Remove the spark plug. Pour a
tablespoon of engine oil into the cylinder
.
Turn the engine slowly using the cable to
distribute the oil.
Reinstall the spark plug.
Change the engine oil.
When collected from storage - drain the
stored petrol into suitable containers for
disposal.
and fill with fresh petrol before starting.
Possible cause
Solution
Check and refuel
Check and top up
the oil
Check and replace
spark plugs
Clean the fuel
sediment tank
Turn the AC
switch
Check that the
appliance or
electrical
equipment has no
defects
Switch on DC
protection
Check that the
appliance or
electrical
equipment has no
defects
Value
208 cm3
230 V AC
50 Hz
2800 W
Peak output power
Additional output voltage
Power of additional output
Degree of protection
Protection class
Idle speed
Internal combustion engine power
Performance class
Power factor (cos φ)
Type of fuel
Fuel tank capacity
Average fuel consumption
Engine oil type
Oil
quantity
for
combustion engine
Spark plug type
Maximum ambient temperature
Dimensions LxWxH
Mass
Year of production
04-730 indicates both the type and the designation of the
machine
NOISE AND VIBRATION DATA
Sound pressure level
Sound power level
Information on noise and vibration
The noise emission level of the equipment is described by: the emitted
sound pressure level Lp
A
measurement uncertainty). The vibrations emitted by the equipment are
described by the vibration acceleration value a
measurement uncertainty).
The sound pressure level Lp
vibration acceleration value a
measured in accordance with ISO 8528-10:1998. The vibration level a
given can be used to compare equipment and to make a preliminary
assessment of vibration exposure.
The vibration level quoted is only representative of the basic use of the
unit. If the unit is used for other applications or with other work tools, the
vibration level may change. A higher vibration level will be influenced by
insufficient or too infrequent maintenance of the unit. The reasons given
above may result in increased vibration exposure during the entire working
period.
In order to accurately estimate vibration exposure, it is necessary to
take into account periods when the unit is switched off or when it is
switched on but not used for work. Once all factors have been
accurately estimated, the total vibration exposure may turn out to be
much lower.
In order to protect the user from the effects of vibration, additional safety
measures should be implemented, such as cyclical maintenance of the
machine and working tools, securing an adequate hand temperature and
proper work organisation.
ENVIRONMENTAL PROTECTION
Electrically-powered products should not be disposed of with household
waste, but should be taken to appropriate facilities for disposal. Contact
your product dealer or local authority for information on disposal. Waste
electrical and electronic equipment contains environmentally inert
substances. Equipment that is not recycled poses a potential risk to the
environment and human health.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with its
registered office in Warsaw, ul. Pograniczna 2/4 (hereinafter: "Grupa Topex") informs that
all copyrights to the content of this manual (hereinafter: "Manual"), including, among
others. Its text, photographs, diagrams, drawings, as well as its composition, belong
exclusively to Grupa Topex and are subject to legal protection under the Act of 4 February
1994 on Copyright and Related Rights (ie Journal of Laws 2006 No. 90 Poz. 631, as
amended). Copying, processing, publishing, modifying for commercial purposes the entire
Manual and its individual elements, without the consent of Grupa Topex expressed in
writing, is strictly prohibited and may result in civil and criminal liability.
EC Declaration of Conformity
Manufacturer: Grupa Topex Sp. z o.o. Sp.k., Pograniczna 2/4 02-285
Warszawa
Product: Generator set
Model: 04-730
Trade name: NEO TOOLS
Serial number: 00001 ÷ 99999
12
3000 W
12V DC
8,3A
IP23M
I
3000 min-1
7.0 HP
G1
1.0
#92; #95; #98
15 L
2.63l/h
SAE15W30
the
internal
0,6 L
Magneto ignition
+ 40°C
72.5x46.5x45 cm
44 kg
2023
Lp
= 69 dB(A) K= 3 dB(A)
A
Lw
= 96 dB(A) K= 3 dB(A)
A
and the sound power level Lw
h
, the sound power level Lw
A
given in these instructions have been
h
(where K denotes
A
(where K is the
and the
A
h
Werbung
