VOSS.farming 85345 Bedienungsanleitung Seite 28

During the charging process, the charging indicator lights up red. As soon as charging is
complete, the charging indicator lights up green.
Info
► Charging takes approx. 1.5-2 hours.
► If the batteries are hot (e.g. from devices that have just been used), the
charging indicator may not light up red. Let the battery cool down first,
preferably outside the charging station.
► If your charging indicator flashes red and green alternately, charging is not
possible. The connections on the battery or the charger may be dusty, worn
or damaged.
5. Remove the battery (4) from the charging station and disconnect the charging
station from the socket.
9.2 SHARPENING BLADES
CAUTION
Sharpening of the blades may only be carried out by specialist dealers using special
machines. Do not sharpen the blades yourself.
10 TROUBLESHOOTING
NOTICE
► Do not make any improper changes or modifications to the device.
► Never open the housing. Contact the service department for repairs.
If the device malfunctions or is found to be otherwise defective, even after following
the suggested solutions below, contact the service department. The contact details can
be found in chapter 14.
Problem
Motor does
not work
Motor vibrates
Motor gets hot
28
Cause
1. Battery empty
2. Battery, switch or
motor defective
1. Rotor runs out of round
2. Bearings are worn out
3. Fan wheel broken
1. Air filter is blocked
2. Blade tension is too
high
3. Blades or clipper head
run dry
4. Defective ball bearing
INSTRUCTION MANUAL VOSS.FARMING PROFICUT GO
Motor
Solution
1. Change and charge the battery as
described in sections 7.4 and 9.1.
2. Contact the service department.
Contact the service department.
1. Clean or replace air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this solves
the problem and the device does not
cut, the blades must be sharpened.
3. Oil the blades/head.
4. Contact the service department.
85345 - 07.2021 - V2