Change-Over-Unit Dx For Air1 Xc, Xh, Rh Units; Cleaning The Change-Over-Unit Dx - Helios AIR1-CO DX-Serie Montage- Und Betriebsvorschrift

Installation and Operating Instructions
EN
NOTE
NOTE
Change-over-unit AIR1-CO DX
33

Change-over-unit DX for AIR1 XC, XH, RH units

1. Loosen and remove the screws to remove the service door (see Fig.27
dual water may still be present.
2. Carefully remove the change-over-unit DX
The fins must not be bent!
3. Remove the M5 screws (Allen screws) on plate 1 and 2 (s. Fig.27).
1
2
4. Clean the condensate tray with a cloth (see Fig.28
34

Cleaning the change-over-unit DX

The must be regularly checked for dirt and dust deposits. If there is dirt and dust on the
– change-over-unit DX
, these can be removed with water.
over-unit DX
– The cleaning can be carried out with water. Household cleaning agents can be used.
– The fins must not be bent!
– When cleaning, ensure that the
Allow the change-over-unit DX to dry before installation
(s. Abb.26).
Fig26
).
Fig28
is not damaged mechanically or chemically
change-over-unit DX
!
17
Carefully remove the panel because resi-
).
.
Fig25
Fig27
change-