Herunterladen Inhalt Inhalt Diese Seite drucken

Your Device At A Glance; Assembly; Operation; Cleaning - Euromate 482331 Originalbetriebsanleitung

Olfreies heizgerat
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
• The device may never be operated without super-
vision.
• Never subject the device to water or other liquids.
• The device may neither be operated in rooms with
a bathtub, shower or swimming pool nor near
washbasins or water connections.
• The distance between the device and flammable
objects must be at least 75 cm.
• The device may not be covered. There is danger
of fire.
• Do not use the heater in conjunction with a timer
or any other switch capable of automatic activa-
tion, as this creates a fire hazard.
• The heater must not be positioned beneath a wall
socket.
• Do not use adapters or extension cords.
• Never pull on the mains cable to move the device.
• This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• Children of less than 3 years should be kept away
unless continuously supervised.
• Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
• CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
• Do not use this heater in small rooms when they
are occupied by persons not capable of leaving
the room on their own, unless constant supervi-
sion is provided.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use be-
fore using the product for the first time.
To prevent overheating, do not cover the
heater!

Your device at a glance

Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, item 1
1. Display
2. Mode (Temperature regulator)
3. Power switch

Assembly

– Place the device upside down on a flat, stable sur-
face, ensuring it will not tip over.
► P. 3, item 2
– Install the rollers as shown on the below drawing
WARNING! Risk of injury! Always use
your appliance with rollers fixed.
– Let a minimum distance of 1m between any side
of your appliance and any obstacle (furniture or
walls, for example) to allow a good circulation of
the airflow.
– Always direct the airflow in order to optimize the
heating of the room.
– Avoid the corners, small volumes, wood floors,
ceiling, etc...

Operation

Check before switching on!
DANGER! Risk of injury! The device must
only be put into operation if no faults are
found during the check-up. If any part of the
device is defective, it must be replaced
before the next use.
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the device are firmly
attached.
– Check whether the switch is on [0] before you
insert the plug into the outlet.
Electrical connection
– Connect mains cable to outlet.
DANGER! Risk of injury! The device may
not be mounted directly below a wall outlet.
Danger of cable fires!
Use
– To start the heater, press power button [ ].
– Rotate the [MODE] to select the target tempera-
ture from 5–35 °C.
– Press [MODE] button to start the power setting,
then rotate the [MODE] to set the power as [H1]–
[H2]. Press [MODE] again to confirm the setting.
Setting
[H1]
[H2]
– Press [MODE] for 3 seconds to set the timer off:
1–24 hours, set 0 hour to turn off the timer func-
tion.
– To stop the heater working, press again power
button [ ].
– Unplug the product when it's not in use.

Cleaning

DANGER! Risk of injury! Before all work
on the device, always disconnect the mains
plug.
– Switch off the device and let it cool off completely.
– Pull out the plug.
GB
Power
1000 W
2000 W
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis