Werbung
Congratulations on purchasing the MIVV exhaust system. The MIVV exhaust system is a product
of MIVV Spa, Zona Industriale Sant'Omero ( TE ), Italy.
Please read this entire installation manual carefully prior to installing and using the
MIVV exhaust system.
MIVV exhaust system should only be installed by persons skilled in motorcycle exhaust system
installation and performance. The instructions provided in this manual should be followed to
ensure proper installation and safe use of the MIVV exhaust system.
MIVV and/or its partners shall not be held liable for any damage or personal injury (including
direct, indirect, or consequential damage) sustained as a result of improper installation of the
MIVV exhaust system or its use and maintenance contrary to the instructions and warnings
contained herein.
If you have any questions regarding the installation and/or proper use of the MIVV exhaust
system or this manual, please contact your local MIVV partner.
For more information on the MIVV exhaust systems, see the official MIVV website at:
http://www.mivv.com
GENERAL INFORMATION
All statements made with regard to the exhaust system's compliance are made in respect of the
exhaust system "as is". Any modifications of the MIVV exhaust system or its improper
installation, use or maintenance that is not in accordance with this Installation manual, may
result in severe damage to the exhaust system and/ or engine, as well as personal injury, and
may affect the exhaust system's compliance with the legal requirements, such as exhaust
system's air and/ or noise emissions (as an example, the motorcycle may not be suitable for use
on public roads any longer), as well as warranty coverage.
The exhaust system may only be used in accordance with relevant laws and regulations,
including state and federal, where applicable.
Damage caused by improper installation, use and maintenance of the MIVV exhaust system is
not covered by the MIVV warranty. Please refer to the enclosed warranty with regard to the
terms of our warranty.
Technical specifications of MIVV exhaust systems and related products are subject to change
without notice.
Make sure that you have all the parts necessary for the installation of your new MIVV
exhaust system.
If any of the parts is missing, please do not proceed with uninstalling your stock exhaust
system/ installing the MIVV exhaust system and contact the retailer where you purchased the
MIVV exhaust system.
After installation it is recommended to check all screws to be properly tightened.
When tightening original screws please follow the indications given in vehicle's maintenance
manual, for hardware given in the fitting kit please follow the values listed.
SCREW SIZE
M5
M6
M8
M10
M12 (SONDA)
M18 (SONDA)
TIGHTENING TORQUE
5,5 Nm
9,5 Nm
21 Nm
42 Nm
24 Nm
28 Nm
2
Werbung
