If The Appliance Is Not Used For A Long Period Of Time; Troubleshooting - Amitek AKD100W Handbuch Zur Installation, Bedienung Und Wartung

6.4 If the appliance is not used for a long period of time:


Remove all food and drink from the appliance and transfer into another refrigerator or freezer;

Disconnect the plug from the electric socket;

Carefully clean and dry the appliance;

Cover the appliance with a fabric sheet which allows air to circulate but also protects it from
dust and dirt.

7. Troubleshooting

PROBLEM
Insufficient cool-
ing power
Not cooling
The appliance
leaks water
Very noisy
The compressor
does not shut off
automatically
The above cases are presented merely as examples of possible problems. In the event of any prob-
lem, immediately switch the appliance OFF and contact the dealer.
- 32 -
CAUSES
 Direct sunlight or near heat sources.
 Control unit is performing a defrost cycle.
 The door is not completely closed or has
been opened too long.
 The door seal is damaged or deformed.
 The evaporator is covered in ice.
 Dirty condenser coil.
 The electric plug is not inserted in the
socket.
 The compressor does not turn on.
 Power failure.
 The water elimination device is damaged,
the discharge has not been well channelled
or is blocked.
 The appliance is not positioned on a flat
surface or the legs are not properly ad-
justed.
 The appliance is not positioned on a flat
surface or the legs are not properly ad-
justed.
 There is a vibration caused by loose screws
or bolts.
 Too many products inside the appliance.
 The door is not closed or has been opened
too long.
SOLUTION
 Move the appliance away from the heat
sources.
 Wait for the control unit to complete the
defrost cycle (max. 20 minutes).
 Close the door completely, keep the door
open for shorter periods of time.
 Contact the dealer.
 Check that the door and the gasket seal
well and that no hot food has been put in-
side the appliance. Contact the dealer.
 Clean the condenser coil (see section 6
"Cleaning and servicing").
 Insert the electric plug in the socket.
 Contact the dealer.
 Check the power supply.
 Make sure that the water elimination de-
vice is well channelled and the discharge is
not blocked.
 Place the appliance on a flat surface and ad-
just the legs so that the appliance rests sol-
idly on the ground.
 Place the appliance on a flat surface and ad-
just the legs so that the appliance rests sol-
idly on the ground.
 Check that the screws and bolts have not
become loose during operation or
transport.
 Remove excess products.
 Only open the door as long as necessary
and check that it is properly closed.
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS