Sony HMI-3000MT Bedienungsanleitung Seite 24

• Make sure that the HMO-CA50M head mounted
display cable (hereinafter called the display cable)
cannot become snagged around feet and legs. If the
display cable is snagged and jerked, there is a risk that
the head of the person wearing the head mounted
monitor will be jerked.
Carrying the unit
Hold the unit firmly when moving around with the head
mounted monitor or HMI-3000MT head mounted image
processor unit (hereinafter called the image processor
unit) to avoid dropping the unit. Dropping the unit may
cause an injury. Also, the unit contains high-precision
components that may be damaged if the unit is dropped.
If the unit is dropped, contact your local Sony distributor
or sales representative.
FS-24 foot switch (not supplied)
The FS-24 has an Ingress Protection Rating of IPX3.
Therefore, it cannot be used in locations subject to
splashing liquids (e.g., operating rooms). For safety, use a
product with a rating of IPX6 or higher in such
environments.
In addition, if a malfunction occurs with the foot switch
during operation, disconnect it from the image processor
unit, and perform operations from the front panel.
Condensation
If the unit is suddenly taken from a cold to a warm
location, or if ambient temperature suddenly rises,
moisture may form on the outer surface of the unit and/or
inside of the unit. This is known as condensation. If
condensation occurs, turn off the unit and wait until the
condensation clears before operating the unit. Operating
the unit while condensation is present may damage the
unit.
24
Precautions
Deterioration of contact pad surface
If the surface of the pads (front pad, side pad, top pad) or
headband deteriorates, starts to peel off, or looks like it
will peel off, cease using the unit in medical procedures
and contact your local Sony distributor or service
representative.
Storage of packaging materials
If you need to transport the unit for repair or any other
reason, use the same box and cushion materials provided
when the unit was purchased.
Before storing the head mounted monitor in the box,
adjust the headband and rear band so that they are as short
as possible, and set the headband lock switch to the
locked position.
If the unit is not used for an extended
period of time
• Turn off the power supply to the head mounted monitor
and image processor unit, in that order, and disconnect
the AC power supply cord of the AC adapter.
• Adjust the rear band of the head mounted monitor so
that it is as short as possible.
Cleaning
Before cleaning, always remove the power supply plug
from the power outlet.
Do not sterilize or use an autoclave on the unit.