Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
INSTALLATION
Make sure the package contains all parts necessary for assembling the convector. Contact your vendor
if this is not the case.
Package contents:
1. 1 heat convector
2. 2 bases
3. 4 attachment screws
4. 1 operating manual
Unplug the device, prior to any form of manipulation, to prevent injury by electric shock.
Requirements on installation
Place the convector on a flat surface with a sufficient amount of space around the appliance to ensure
the proper function of exhaust vents.
The distance between the device and the closest wall must be at least 50 cm.
Warning:
To prevent the device from overheating, do not cover the heater.
The heater must not be placed directly under an outlet.
1. Place the convector on a flat surface.
2. Press the base pegs into the holes found on the bottom part of the convector.
3. Tighten the screws carefully and check to see the convector is stable.
attachment screws
20
Werbung
