Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Safety Notes
The unit (amplifier with power supply unit)
corresponds to all relevant directives of the
EU and is therefore marked with
WARNING The power supply unit uses dan-
gerous mains voltage. Leave
servicing to skilled personnel
only. Inexpert handling of the
unit may result in electric shock.
G
The unit is suitable for indoor use only. Pro-
tect it against dripping water and splash
water, high air humidity and heat (admissi-
ble ambient temperature range: 0 – 40 °C).
G
Do not place any vessel filled with liquid on
the unit, e. g. a drinking glass.
G
Immediately disconnect the mains plug
from the socket
1. if the amplifier, the power supply unit or
the mains cable is visibly damaged,
2. if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3. if malfunctions occur.
In any case the unit must be repaired by
skilled personnel.
G
Never pull the mains cable to disconnect
the mains plug from the socket; always
seize the plug.
G
For cleaning only use a dry, soft cloth;
never use water or chemicals.
G
No guarantee claims for the unit and no l ia-
bility for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not correctly installed or
operated or if it is not repaired in an expert
way.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not
harmful to the environment.
3.1 Conformity and approval
Herewith,
declare that theunit AKB-90WIFI is in accor-
dance with the basic requirements and the
.
other relevant regulations of the directive
2014/ 53 / EU. The declaration of conformity
is available on request from MONACOR
INTERNATIONAL.
The unit operates in the 2.4 GHz range
and is generally approved for operation in EU
and EFTA countries and is licence-free.
4 Installation
1) Place the amplifier at a suitable location
and, if required, fasten it using screws.
2) Insert the antenna (1) into the jack ANT (2);
then tighten the antenna and place it in a
vertical position.
3) Connect the speakers to the jacks
[Right OUT for the right channel, LEFT
OUT for the left channel].
To obtain the highest output power,
connect speakers with an impedance of
4 Ω. It is also possible to connect speakers
with higher impedance; this, however, will
reduce the output power accordingly.
4) Finally, connect the power supply unit to
the jack DC IN (3) and the mains plug to a
mains socket (230 V~ / 50 Hz). The ampli-
fier will be switched on.
When the amplifier is not used for a
longer period of time, disconnect the
power supply unit from the mains socket to
save power.
MONACOR
INTERNATIONAL
(5)
9
Werbung
Inhaltsverzeichnis
