Clearaudio VTA-Lifter Bedienungsanleitung Seite 5

User manual / Bedienungsanleitung
2. Installation on Clearaudio turntables
2.1. Installation on a Solution base
For the installation please remove the tonearm and the base from your turntable.
VTA-Lifter
Fit the (2) from above through the hole of the base.
Pic. 2: Mounting the VTA-Lifter
VTA-Lifter
Please mount the
VTA-Lifter
Tighten the
bottom side of the Solution – base (see pic. 3).
Now you can mount the Solution base on the turntable chassis again.
2.2. Tonearm set up (only for Clearaudio Radial tonearms)
To install a Clearaudio radial tonearm (e.g. Unify, Satisfy and Universal) please pull the cable carefully
VTA-Lifter
trough the hole of the
After you have set up the tonearm into the hole please make sure that the tonearm is exactly on the line
between "+" and "-"(top view) (see pic. 3) on the
Pic. 3: Installation of the
Made in Germany
in a Solution base
(2) with the lever rearwards (see pic 2).
(2) with the delivered cylinder head bolts and the hex key wrench (3 x 8) on the
(2).
swing base
Bottom side of the Solution base
Pic. 3: Tighten the
base
VTA-Lifter
(2).
VTA-Lifter
in a Solution
5