Conrad 67 15 89 Bedienungsanleitung Seite 33

Recording videos
Press the "MODE" button repeatedly until the video camera symbol starts
flashing. Press the "SET" button.
Press the "SET" button to start or stop recording video. The video is saved as
an AVI file (resolution 320 * 240 pixels).
Setting the mains frequency (50 Hz or 60 Hz)
Press the "MODE" button repeatedly until "50" or "60" starts flashing. Press the
"SET" button to confirm your selection.
Only make an adjustment if you want to take pictures in a big room with
fluorescent tubes to prevent possible lines in the pictures. If used outdoors, no
adjustment is necessary.
Deleting the last picture
Press the "MODE" button repeatedly until the symbol shown to the left starts
flashing. Press the "SET" button. The symbol is displayed permanently (symbol
stops flashing). Press the "SET" button quickly to delete the last picture.
Deleting all saved pictures
Press the "MODE" button repeatedly until the symbol shown to the left starts
flashing. Press the "SET" button. The symbol is displayed permanently (symbol
stops flashing). Press the "SET" button quickly to delete all saved pictures.
Three-digit display
The number of saved pictures is represented by a number (when memory is
full, "FUL" is displayed). When a PC connection via USB has been established,
"PC" is displayed.
Battery symbol
Battery full (voltage > 3.9 V)
Battery low (voltage between 3.6 V and 3.9 V); an audio warning is played
Battery empty (voltage lower than 3.6 V); the camera goes off automatically
after a short time
33