Get Started - RUSTA 903014070101 Gebrauchsanweisung

GET STARTED!

• Before using the milk frother, all parts should be cleaned as explained in
"CARE AND CLEANING".
IMPORTANT: Do not wash any parts in a dishwasher and do not immerse the jug
in water. This may permanently damage the product and the warranty will
no longer be valid.
• The appliance is equipped with mixing and frothing whisks. The mixing whisk is
used to stir the milk while it is being heated so that it does not burn. The frothing
whisk is used to froth the milk when it is being heated, or just to froth it without
heating it. Choose the desired accessory depending on what you want to do.
• The amount of milk to be heated or frothed must not exceed the maximum mark as
shown in figure 1.
NOTE: The maximum capacity of the jug is 300 ml.
USE
1. Place the appliance on a flat surface.
2. Choose the frothing whisk (if you want to froth milk) or the mixing whisk (if you want to
heat milk). Then open the lid and attach the selected whisk to the shaft in the bottom.
3. Fill the jug with the required amount of milk and put the lid on.
NOTE: When frothing milk, the maximum permitted amount of milk is 150 ml
(see figure 1), otherwise the milk will overflow during frothing. The minimum
permitted amount of milk is 75 ml.
When heating milk, the maximum permitted amount of milk is 300 ml (see figure 1),
otherwise the milk will overflow as it is being stirred. The minimum permitted
amount of milk is 75 ml.
Maximum capacity for heating milk (300 ml).
Maximum capacity for frothing milk (150 ml).
Minimum capacity for heating or
frothing milk (75 ml).
Figure 1
7