Werbung
Verfügbare Sprachen
Verfügbare Sprachen
There is a fire risk if cleaning is not carried out
in accordance with the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
Notes: cleaning in the dishwasher with
aggressive
detergents
surface of metallic parts, without this affecting
its gas retaining properties.
N.B. The filter must be cleaned at least once a
month depending on how often the extractor is
used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
Never use metallic scouring pads or
abrasive products that could damage
the surface.
Do not use scrapers with metallic
surfaces such as knives, scissors etc.
Activated charcoal filter
To install the charcoal filters it is
necessary to firstly remove the
metallic grease filters.
In order to fix them they will be
coincide the later sideburns of each
filter in the anchorage anticipated for
it in the security grid doing them to tilt
upwards until its fixation with the
frontal eyelash of the same one
(Fig.6).
The carbon filters last from three to
six months depending on the
particular conditions of use.
may
blacken
the
The activated carbon filters can
neither be washed nor regenerated.
Once they are exhausted, they must
be changed.
To replace used filters with new ones,
withdraw the old ones in the reverse
order to that of installation.
Tecnical Information (Fig. 4)
Dimensions:
Electrical characteristics:
REFER TO RATING PLATE
Installation
To fix the cooker hood please choose one of
the following options:
a) Fixing to the upper part of the furniture
Figure 3 must be used where the position of
the holes is indicated.
b) To the internal side of the furniture (without
brackets):
When the body hood fits within the furniture,
fasten with two screws on each side from
the inside of the body hood, using their side
holes.
c) Fixing to the internal laterals of the furniture
(with brackets):
1.-Screw two screws to each side of the
furniture
interior
instructions (A or B depending on the width
of the furniture). Leave them 3 mm loose for
adjustment.
2.-Screw the provided brackets to the top
part of the hood, keeping the internal
furniture width.
3.-Hold and rise the hood until the slots of
their brackets fit in the screws (step 1) of the
furniture.
17
Width = 600//900 mm
Depth = 300 mm
Height = 343 mm
following
figure
EN
5
Werbung
