Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Trouble Shooting
In case of breakdown, switch the motor off and disconnect
it from the power. Repairs of the electrical parts may only
be performed by an authorised service specialist.
Trouble Shooting
Error
Machine does not
work.
motor runs, drill bit
does not rotate
drilling speed too
slow
motor shuts down
water drops out of
the gearbox housing
Possible Cause
mains current supply interrupted
line cord or plug damaged
switch damaged
the PRCD-switch is off
Gear not engaged properly or
accidentally disengaged
gearbox damaged
drill bit damaged
A too high water flow rate
prevents self-sharpening of the
drill bit
drill bit polished
the tool stops
the tool overheats, overload
protection of the motor has
reacted
shaft sealing rings damaged
Error Recovery
plug in another electric
appliance and check the
functioning
have it checked by an electric
specialist and replaced if
necessary
have it checked by an electric
specialist and replaced if
necessary
press RESET to switch on
Operate the gear switch to
engage the required gear
have the tool repaired by an
authorised service workshop
check if drill bit is damaged and
replace it if necessary
regulate the water quantity
sharpen the drill bit with a
sharpening stick while using the
flush
lead the tool in a straight
manner
discharge the tool and restart it
by pressing the switch a couple
of times
have the tool repaired by an
authorised service workshop
27
Werbung
