Suntec Wellness KLIMATRONIC DryFix 20 Lumio Bedienungsanleitung Seite 14

Description of the functions
On/Off:
• Please connect the plug of the device to a power outlet.
Please make sure the water tank is empty before switching on the device.
•
Please open the air outlet manually.
•
• Please press the On/Off button (6) to switch the device on or off.
• The unit will automatically start with the previous setting when it is turned on.
Mode:
Please press the mode button (5) after turning on the unit to select between ventilation function, dry clothes,
•
continuous dehumidification or automatic dehumidification.
Continuous dehumidification:
Please press the mode button (5) to switch on the continuous dehumidification function. The continuous
•
dehumidification indicator (11) lights up. In this mode, you can set the desired dehumidification level, the unit
dehumidifies with low ventilation speed (not adjustable).
Please use the up and down buttons (2 and 4) to set the dehumidification level from 30% - 80%.
•
• To switch on continuous dehumidification regardless of the existing humidity, please press the down key (4)
until "CO" appears on the display.
Automatic dehumidification:
Please use the mode button (5) to switch on the "automatic dehumidification" function. The automatic
•
dehumidification indicator (12) lights up.
The ventilation speed and humidity level cannot be set in this mode. The unit dehumidifies automatically and
•
with high ventilation speed when the ambient humidity is ≥70% and with low ventilation speed at 55%-70%
humidity. If the ambient humidity is below 50%, the compressor turns off, only the ventilation function remains
active at low speed.
Dry Clothes:
• Please press the mode button (5) to switch on the dry clothes function. The "dry clothes" indicator (10) lights
up.
• The ventilation speed and humidity level are set automatically and cannot be adjusted manually. The device
dehumidifies automatically and at a high ventilation speed.
With this function, you can dry clothes, shoes or carpets faster.
•
Ventilation mode "Clean air":
• Please press the mode button (5) to switch on the ventilation function. The "Air clean" indicator (9) lights up.
In this mode, only the fan is operation at a low level, and the air is cleaned by the integrated active carbon filter.
•
Timer:
When the unit is on, please press the timer- button (1) to set the desired time hour by hour from 0-24 hours.
•
Light indication:
• If the ambient humidity is below 50%, the indicator light will turn blue.
• If the ambient humidity is between 50% and 70%, the indicator light is green.
If the ambient humidity is above 70%, the indicator light is red.
•
Drainage
Water tank:
• As soon as the water tank is full, the device stops operating, a warning tone sounds
and the "Water tank full" indicator (8) lights up.
Please switch off the device and disconnect the power plug.
•
• Please pull out the water tank carefully and tip out the water by using the handle.
Clean the empty tank and then carefully push it back into the unit.
•
Continuous drainage:
Please disconnect the power plug.
•
• You will find the drainage opening on the back of the unit (7).
Please insert the drainage hose into the opening and replace the water tank.
•
Please place the other end of the hose into a collection container so that the water can continuously drain away.
•
• Please make sure that the hose is tightly connected to prevent the water from leaking.