Zipper ZI-MD300 Originalbetriebsanleitung Seite 38

13.4 Fill with oil
Fill the oil (SAE 10W-30 or 10W-40) 0.6 L in the oil tank.
Between measure used by the dipstick -without tighten up- between the upper max and
lower min mark. Caution: Do not overfill
The engine is delivered without oil: Fill in 0.6 liter oil before
starting the engine!
ANY FINAL JAM NUT AND BOLT ON ANY DEAD TIGHT!
WHILE OPERATING THE VIBRATING MACHINE STRONG, NOT TIGHTEN THE
SCREWS CAN BREAK OFF AND LOST AND DANGEROUS SITUATION TO BE
CARRIED!
14 OPERATION
14.1 Operating notes
Engine Oil as described in 13.4
14.2 Operating
14.2.1 Start Engine
Start the engine, if you have your mini truck mounted correctly:
Set the lever (7) to the neutral position.
Move the choke lever on the machine to the full choke position.
Turn engine switch to "ON".
Pull the starter rope several times so that the carburetor is filled with gasoline.
Pull the starter handle, pull-out until resistance is felt. Let the rope rewind slowly across
and then move expeditiously.
Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
Set the choke lever after a few seconds of engine run position ˝OPEN˝
To start the engine is warm the choke lever is not to be operated.
When the engine is warmed up, pull the clutch lever and insert the desired gear. If the
desired response can not insert, release the clutch lever and repeat the process. The mini
van starts to drive. Pull the throttle to match the speed set.
With the steering arm on the handles and can be easily controlled. To drive in the desired
direction each use the right or left steering lever.
14.2.2 Idle
Throttle lever to the "SLOW" (SLOWLY) take to protect the motor if no work is done.
Downshifting the engine to idle prolongs the life of engine reduces fuel consumption and the
noise level of the machine.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Miniraupendumper / Mini transporter ZI-MD300 ZI-MD300G ZI-MD500 ZI-MD500H
A T T E N T I O N
OPERATION
Seite 38
Seite 38