MARIMEX Tampa Anweisungen Für Die Installation Seite 25

• Contact your dealer for swimming pools and accessories and get advice on how
to properly clean the pool water to maintain and non-toxic. One of the most im-
portant factors, how to extend the life of the filter cartridge is the maintenance
of clean water. Maintenance follow the instructions your dealer.
• Place a shallow paddling pool with water next to the pool, so that the
bather's person could cleanse feet in front of the entrance to the swimming
pool.
• Cover pool cover or solar sail, when not in use. To reduce the load of dirt from
the pool area.
• Inflatable ring clean. After each use with a soft cloth to wipe debris. Do not use
any of concentrated cleaners, abrasive products or solvents.
• Regularly clean the bottom of the pool from established impurities.
• Filter cartridge in filter unit change every 2 weeks. In doing so, remove the debris
with a clean cloth on the inside walls of the filter unit.
• Use chemical products intended for swimming pools. The application of prepara-
tions in the form of chlor tablet, we recommend using a Board specially designed
for this purpose. Follow the instructions on the packaging of individualproducts.
Avoid contact with chemicals the pool material, until they are completely dissol-
ved in the pool water. Preparations first perfectly melt in a smaller amount of
water (e.g. in the bucket) and only then is it to apply to the pool with caution, to
avoid contact with the pool. Never mix chemicals together, you may experience
unexpected reaction. The swimming pool is to apply gradually and separate-
ly. Chemicals do not apply when the pool is being used. It can cause irritation to
eyes, skin, or other difficulties.
Attention: Heavy rain can cause the collapse of a swimming pool. As a preventive
measure before the advent of heavy rainfall, lower the water level in the pool and
reduce until the rains could never be quenched.
Instructions for the removal and storage of
• Important: If it is expected that the temperature drops below 5° c, the pool sto-
re.
• All components should be cleaned should use SOAP and lukewarm water. DO
NOT USE any solvents or hot water.
• Make sure , that all the parts are in storage before completely dry. Pre-
vents the formation of this mold in places fold foil.
• Store all parts in a dry heated place, where the temperature does not drop below
4 ° c or 50 ° c. In the case of non-observance of these instructions for the storage
pool may be damaged, and is the reason for the cancellation of the warranty.
• Follow the Assembly instructions listed above, in order to build again at the next
pool season. The site for the pool must be before a new Assembly of the pool
again, checked and balanced.
• If you want to drain the pool, locate the drain hole on the outer side of the wall
of the pool and remove the drain Cap. Connect a garden hose and stretch it to
the location where you want the water to drain. After you place the hose in the
desired location, you can open the stopper on the inner side of the swimming
pool.
EN
25