Hendi 239445 Gebrauchsanweisung Seite 7

Setting Power / Temperature level
• During operation, press the Function setting (1)
to choose different function. Power function in-
dicator (8) or temperature function indicator (9)
lights up.
• Press the Increase setting (2) or Decrease set-
ting (4) to increase or decrease the power level
(Range: 100W ~ 1,800W for left; 100W ~ 1,700W
Setting Timer
• After power or temperature setting for cooking,
you can opt for timer setting. Press the timer fuc-
tion (5) to activate. The indicator light 5) lights up.
• The timer shown on the digital display (4) is in
the form 0:00 (where 0 = 1, 2 or 3 hour; 00 = 01 ~
59 minutes).
• Press the Increase setting (2) or Decrease set-
ting (4) to increase or decrease the cooking time
(Range: 0 min ~ 180 mins). Default setting is 0
min.
Boost function
• Press boost function button (7) to increase the
maximum power setting to 2000W for left plate
only. The maximum power setting of right plate
will change to 1500W. Boost indicator (7) lights
up.
Note:
1) Press and hold the Increase setting (2) or De-
crease setting (4) for fast adjustment.
2) After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in Standby mode for some time. Before
unplug the appliance, wait until the cooling fan
stops running.
for right) or temperature level (Range: 35ºC -
240ºC for both). Default setting is 100W / 35ºC
separately.
• Higher power level is suitable for steaming. And
higher temperature level is suitable for roasting,
grilling or frying.
• When the timer is set, it will be stored automat-
ically within 5 seconds. The appliance will then
start operation. It will display the remaining time
and the power setting / temperature level alter-
nately on the display (3).
• The appliance will switch off when the set time
is elapsed and all the light indicators will go off.
• Boost function can operate for 10 minutes each
time. The maximum power setting of both heat-
ing plates will be returned to normal automati-
cally after 10 minutes. Or press boost function (7)
again to cancel it directly.
3) The appliance's surface is still hot even after
switch to Standby mode. Wait completely cool
down before touching.
EN
7