Troubleshooting - Saeco HD 8425 Bedienungsanleitung

13

TROUBLESHOOTING

Problem
The machine does not switch
on.
The machine turns off while
brewing coff ee or dispensing
hot water.
The pump is very noisy.
Coff ee is not spilling out after
turning the selection knob (17)
to the " " position.
Coff ee is too cold.
The milk does not froth.
It is not possible to prepare a
cappuccino.
Coff ee is brewed too fast, crema
does not form.
• 30 •
Possible Causes
The machine is not connected to the electric
network.
Energy saving mode is on.
No water in the tank.
Filter holder is clogged.
The "machine ready" light (20) was off while
switching the selection knob (17) to the "
" position.
The fi lter holder is not inserted for preheat-
ing (chapter 5).
The cups are cold.
The milk is not suitable: powdered milk,
low-fat milk.
Dirty Pannarello.
There is no more steam in the boiler.
There is too little coff ee in the fi lter holder.
The grind is too coarse.
Coff ee is old or not suitable.
The pod is old or not suitable.
Missing component in the fi lter holder.
Solution
Connect the machine to the electric network.
Press the ON/OFF button (11) to turn on the machine
and restart brewing.
Fill the water tank and prime the circuit again (section 4.5).
Turn the selection knob (17) back to the " " position.
Turn the machine off and let it cool down (approx. 1
hour). Then remove and wash the fi lter holder thor-
oughly. If the problem persists, contact the service
centre.
Wait until the light (20) turns on.
Preheat the fi lter holder.
Preheat the cups with hot water.
Use whole milk.
Clean the Pannarello as described in chap.10.
Prime the circuit (section 4.5) and repeat the steps de-
scribed in chapter 8.
Add coff ee (chapter 5).
Use a diff erent blend (chapter 6).
Use a diff erent blend (chapter 6).
Change the pod.
Make sure that all the components are present and
properly installed.