Parkside Performance PSSAP 2028 A1 Originalbetriebsanleitung Seite 56

Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment that are specified in the oper-
ating instructions and are compatible with
the appliance. Using attachments or accessory
tools other than those recommended in the
operating instructions can lead to a risk of injury.
Information on saw blades
You can use any saw blade provided it is fitted with
a suitable mount – ½" (12.7 mm) universal shaft.
Saw blades optimised for your sabre saw are avail-
able from retail stores in different lengths for
various purposes.
NOTE
► TPI = teeth per inch = the number of teeth
per 2.54 cm
Wood saw blade
Dimensions: 152 x 1 mm, 6 TPI
Ideal for: sawing construction wood, chipboard,
panels and plywood, and also plunge cuts.
Bi-Metal Saw Blade
Dimensions: 150 x 0.9 mm, 24 TPI
Best suitability: for sawing sheet metal, profiles and
pipes.
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
PSSAP 2028 A1
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket.
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack
in the appliance.
Removing the battery pack
♦ Press the release button
battery pack .
Checking the battery charge level
♦ Press the battery charge level button
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
to the high-speed
(see fig. A).
lights up red.
flashes, this means
has overheated and
both
into the appliance.
for at least 15 minutes
to click into place
and remove the
to check
GB │ MT
│ 49
is
is
■