Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Avoid the danger of death
from electric shock!
Before using this product, verify the available
mains voltage corresponds with the required
operating voltage of the product (230 V∼).
Do not use the product if you detect any kind
of damage.
The product contains delicate electronic com-
ponents. For this reason it is possible that it can
be disrupted by radio transmitting equipment
in the immediate vicinity. If you experience faults,
remove such equipment from the vicinity of
the light.
Never allow the product to come into contact
with water or other liquids.
The LEDs cannot be replaced.
Always unplug the mains plug from the socket
before assembly, disassembly or cleaning.
This product does not contain any parts that
can be serviced by the user.
The product may only be used with the built-in
LED controller.
Please note, with the LED mood light plugged
in it still uses a small amount of power whilst
off. Unplug from the socket to switch the device
off completely.
Safety Instructions
for Batteries
DANGER TO LIFE! Batteries
are not intended for children. If accidentally
swallowed seek immediate medical attention!
CAUTION!
EXPLOSION HAZARD! Never
recharge non-rechargeable batter-
ies, do not short-circuit and / or open batteries!
Never throw batteries into fire or water!
Do not exert mechanical loads to batteries!
Risk of battery leakage
In the event of a battery leak, immediately re-
move it from the device to prevent damage!
Avoid contact with the skin, eyes and mucous
membranes! In the event of contact with battery
10 GB/IE
acid, thoroughly flush the affected area with
plenty of clean water and seek immediate
medical attention!
Avoid extreme conditions and temperatures
which may affect the batteries, e.g. on radia-
tors/ in direct sunlight.
Remove the battery from the device if it will not
be used for a prolonged period!
Risk of equipment damage
Only use the specified battery type!
When inserting the battery ensure the correct
polarity! This is shown in the battery compart-
ment!
If necessary, clean the battery and device
contacts before inserting the battery!
Promptly remove drained batteries from the
product!
Start-up
Colour Changing LED Mood Light
Place the LED mood light
solid surface.
Plug into a socket. Verify the available mains
voltage corresponds with the required operat-
ing voltage of the product (230 V∼).
The LED mood light will now light up white
on the second highest brightness setting.
The LED mood light is now ready for use.
Remote control
Remove the insulating strip
battery
and the battery compartment
16
in the remote control
Note: Please remember the remote control
uses infrared light. The signal cannot be trans-
mitted „around the corner" as radio waves do.
Light-tight objects may not be located between
the infrared diode
on a level and
1
between the
17
before use.
2
and the light.
14
13
Werbung
