Inhaltsverzeichnis
Werbung
It's also possible to pair the device via
the "AP Mode", press the button at the
top right, hold down the "
button, you will hear a "Bip" acoustic
signal and and will flash
WI-FI phone settings and connect to
the "Bimar" network Live Smart xxx" or
"Smart Life xxx" and then press
"connect now".
If the operations described above do not proceed correctly or the device is "Offline", the device
must be reset, operating as follows: remove the plug from the socket, and leave the fan heater
disconnected for 30 seconds. Re-insert the plug into the socket of the fan heater. Press the "
" button for about three seconds: a "Beep" acoustic signal will be heard, release the button and "
"symbol on the display will flash quickly;
Settings and customisations
Open the smartphone screen and press
functions: Home management, Message centre, Assistance centre, Configure, In-APP purchases.
Press
in the bottom centre to customise operation of the device to suit the various scenarios or
operating situations provided by the APP (for example: Back home, Leaving home, Dawn, Goodnight,
Temperature, Humidity, Weather, Air quality, Dawn/dusk) or in combination with other devices.
Press
in the bottom left corner and then in the top of the screen, for example:
customise (update and/or change where permitted) the appliance's position or the outdoor wind
speed, air pressure, humidity and temperature (see right).
Press
top right to customise the following: Change Device name, Device position, Check Network,
Third-party devices supported: Amazon Alexa, Google Assistant, Device sharing, Create a Comment
group, Device Info, Feedback, Update Firmware, Remove device, Reset to factory settings.
The smartphone must be connected to Wi-Fi or cellular data network for remote control.
Voice control
The device is compatible with Amazon Alexa and Google Assistant voice controls. Open the
corresponding App/connect the Skill (make sure that the account and password used are the same
as those of the "Bimar Live Smart" app) and follow the settings.
Google Home
: some basic vocal commands are:
- "OK Google" or "Hey Google", turn on XX (name of the device)
- "OK Google" or "Hey Google", turn off XX (name of the device)
"
, open the
in the bottom right corner to customise the following
24
to
Werbung
Inhaltsverzeichnis
