Inhaltsverzeichnis
Werbung
Acoustic warning: an acoustic signal is emitted for each key selection.
Auto Dim. It darkens the display (the leds of the selected functions remain on if you don't perform
any operation within 1 minute of switching it on: touching any key turns the display back on.
The heater is equipped also this safety function: safety device, which turns off the appliance in the
event of overheating. To start it again, remove the plug from the mains and allow it to cool
(approximately 10/20 minutes).
Smartphone
In addition to the control via the control panel and the remote control, the heater can be controlled
via smartphone.
Description
Wifi heater, usable via Smartphone via application with Android or iOS operating systems.
•
Adjustable selections via the Bimar Live Smart APP.
•
The APP installation and configuration procedure may be slightly different from what is described
in this manual; proceed as indicated in the APP.
•
We are not responsible for problems caused by the internet line, the Wi-Fi router and other smart
devices.
•
Check that the router is for domestic use, that the WiFi network has no access restrictions other
than the password, and the presence of a strong and uniform WiFi signal in the room where the
appliance is to be installed and used. In general, routers have set up dual-band, i.e. based on dual
frequency (2.4 and 5)GHz.
To activate and configure the device, you only need to set the
fixed frequency at 2.4GHz (access the IP address of the router
and search for the network settings section (image on the side,
refer to it as an example; if in doubt, contact professionally
qualified personnel). For subsequent uses of the device, if
desired, reset the router to dual frequency.
•
Make sure that the smartphone is connected to the wi-fi network to be used for the appliance.
Standby/OFF
(fan)
mode:
air: 2000W)
automatic automatic louver swing
Increase Temperature
Decrease Temperature
20
->
(hot air: 1200W)->
+
(very hot
Werbung
Inhaltsverzeichnis
