K&H 5Z-KHG-E Gebrauchsanleitung Seite 40

Checking the adjusted flame: heat the burner at full open position for 10 minutes. The turn the
knob into the saving setting. The flame should not extinguish nor move to the nozzle. If it goes off
or moves over to the nozzle, readjust the valves.
Note: It is up to the used to request converting the appliance to another gas type if so required by
the local conditions at a licensed gas fitter/ service.
Flame selection
At the burners adjusted correctly, the flames should be light blue, and the inner cone should be
clearly visible. The size of flame depends on the position of the related burner control knob.
-Burner ON，large flame
See also fig.8 for various operating options(flame size selection); the burner should be set at a
large flame during the initial phase of cooking to bring the food to boiling, and then the knob
should be turned to the saving flame position to maintain the cooking. It is also possible to
adjust the flame size stepless.
It is prohibited to adjust the flame in the range between the Burner OFF and Burner ON
large flame positions.
Significant quantities of energy can be saved if the appliance is used correctly, parameters set
correctly, and appropriate cookware is used. The savings can be as follows：
Up to 60 per cent savings when proper pots are used,

Up to 60 per cent savings when the unit is operated correctly and the suitable flame size

is chosen.
It is a prerequisite for efficient and energy-saving operation of the cooktop that the burners are
kept clean at all times (in particular the flame slots and nozzles).
Fig.7
-Burner ON，small flame（saving mode）
Fig.8
40
-Burner OFF