Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.
Do not screw directly to the hull - must be mounted on a bulkhead or additional mounting board.
6.
WARNING: Fire hazard. Wiring must comply with applicable electrical standards and include a
properly sized fuse or circuit breaker. Improper wiring can cause a fire resulting in injury or death.
Switch off the power while making connections. Suggested wiring information is given as a guide
only. For full information, refer to the USCG, ABYC and ISO regulations for marine applications and
wiring gauges,connectors and fuse protection.
7.
PARTS LIST
Qty 1
Saltwater Washdown Pump
Qty 1
Strainer
Qty 1
Nozzle
8.
INSTALLATION
WARNING: Please note that incorrect installation may invalidate the warranty.
Preparation - Always disconnect power sources before installing.
8.1.
Mounting Instructions
a.
Locate in a dry position with adequate ventilation, no more than 3 metres away from the tank. In
normal use. NOTE ensure the pump cannot be submerged or sprayed by water
b.
Pump can be mounted horizontally or vertically (we recommend that the pump head is below motor
level).
c.
Feet positions are adjustable to allow replacement of other pump types. Use No. 8 stainless steel
screws to fasten pump to solid surface ensuring the pump is securly supported.
8.2
Electrical Wiring
a.
Use specified fuse in the circuit, as indicated on motor label.
b.
Connect red wire to positive and black wire to negative - recommended wire size is 2.5mm (AWG 13)
c.
Fit an isolating switch with adequate current rating on the positive side of the supply.
d.
To prevent the pump running continuously turn off at isolating switch when vessel is left unattended
or water supply has been allowed to empty.
9.
PLUMBING
Check pump flow direction (as indicated on pump body) and ensure that the strainer provided is attached to the
pump head inlet.
10.
INSTRUCTIONS FOR USE
Ensure that pump installation is thoroughly tested before first use. Once installed run the pump ensuring all air is
removed from the system.
11.
MAINTENANCE
This Whale® Wahdown pump is designed to only require minimal maintenance.
WARNING: Before servicing pump, turn off pump and drain water from system, ensuring where relevant all seacocks
are closed. Ensure that the pump is disconnected from electrics and plumbing during maintenance.
Annual Checks - Whale advise that the boat's plumbing system is checked annually for leaks and obstructions. Also
a pump electrics check is advisable.
Optimal Performance - Ensure the strainer is clear of debris
Qty 2
3/4" flexible hose adapters
Qty 2
1/2" flexible hose adapters
Qty 2
3/4" BSP adapter
NOTE: Never
use pipe sealant
or sealing tapes on
threaded adaptors, as
these may enter the pump
and cause failure.
Fig 1
Pump
fittings
Werbung
