Kärcher 2.642-533.0 Bedienungsanleitung Seite 11

1 Unlocking button
 Push both release knobs and remove
the upper part of the banknote reader.
 Remove foreign objects.
If necessary, clean the inside with a
soft, wetted cloth without cotton fibres.
Only use water with dishwashing deter-
gent for wetting.
Notice
Risk of damage. Do not clean the banknote
reader with the following substances: Abra-
sive cleaners or polishing agents, solvents
Fault Possible cause
All coin acceptors Main switch is switched off.
reject all coins
Operating time or holidays set up wrong
A single coin ac- Coin acceptor dirty
ceptor rejects all
coins
Light exposure of coin acceptor.
Fault Possible cause
Orifice of the Fault in the banknote reader.
banknote reader
is flashing
Noises when the Banknote reader soiled.
banknote is
pulled in
Rectify faults
Reset of banknote reader (option)
 Open remote control.
1 Reset button
 Press "Reset" key.
such as alcohol, benzine, printed board
cleaner.
Close the remote control
 Fold away the support.
 Fold the front plate down and press it
shut until the lock arrests.
Troubleshooting
Malfunctions at coin mechanism
Remedy
Set main switch to "1".
Check the settings, operating time, holidays of
the system.
Clean the coin acceptor (see section „Mainte-
nance work")
Only test the coin acceptor while the remote con-
trol is closed.
Faults on the banknote reader (option)
Remedy
Push the reset button (see "Rectifying faults").
Clean banknote reader (see section "Mainte-
nance tasks").
-
EN
Cleaning the outlet
1 Tool storage box
2 Screw
3 Support
4 Drain pipe
 Unlock the lock and open the mainte-
nance door.
 Loosen the screw.
 Push holder to the side.
 Pull down drain pipe.
 Remove obstructions from the tool stor-
age chute and the drain pipe.
4
By whom
Operator
Operator
Operator
Operator
By whom
Operator
Operator
11