Zelmer ZMM9803B Benutzerhandbuch Seite 14

EN
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commercial or industrial use under
any circumstances. Any incorrect use or improper handling of the product shall render the warranty null
and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not use the device, or connect and disconnect to the supply mains with the hands and/or feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle Unplug the product immediate-
ly from the mains in the event of any breakdown or damage and contact
Do not pull on the connection cord in order to unplug it or use it as a handle.
Do not process tough foods, such as bones, nuts (such as dry and hard soybeans) or other food with tough
fiber.
Please utilize the pusher during operation, instead of pushing food by hands.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact an
official technical support service. In order to prevent any risk of danger, do not open the device. Only
qualified technical personnel from the brand´s Official technical support service may carry out repairs or
procedures on the device.
B&B Trends S.L. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
INSTRUCTIONS FOR USE
Meat Grinder
The continuous operation should not exceed 10 minutes; suspend the operation in the event of exceeding
10 minutes and restart the machine after cooling down.
Preparing the meat mincer to work and the actuation of the appliance (C)
Place the drive unit (1) close to the power network socket, on a firm surface so as not to cover the ventila-
tion holes within the casing.
Before the first use of the meat mincer, wash the equipment elements.
Assemble the appropriate equipment and join it with the drive unit.
Plug in the unit.
Turn the meat mincer on with the main switch (1.a)
Operating the mincing set (D)
Insert the following parts into the mincer body (2):
Insert the scroll (3) with the coupling facing inside. Fit the knife (4) onto the pin of the scroll (3).
Place the disc (e.g. 5) over the knife so that the protrusion in the mincer body will fit into the groove in the
circumference of the disc.
Tightly fit all the elements of the mincer unit.
Fit the assembled mincer unit onto the drive unit (1) and turn it until you hear a click of the lock. It means
that the body has been properly installed.
Place the tray (11) on the mincer body (2).
NB: Use only the pusher (8) to push products.
14