Gastroback Design LED Light & Charge Bedienungsanleitung Seite 34

PROPERTIES OF YOUR DESIGN LED LIGHT & CHARGE
Your new »Design LED Light & Charge« is a high-tech energy saving LED light with
additional power output ports for usage as an extra low voltage power supply.
LIGHTING FUNCTION
• The dedicated power adapter provides extra low voltage and smooth, con-
stant output, avoiding any flickering of the light.
• The powerful LED array holds high-quality Osram/Philips LED chips, mounted
in a side-view diffuser assembly to enable smooth and even lighting. Thanks to
this particular design, an even illumination of the workplace is achieved.
• The illuminance and colour temperature of the light can be controlled in sever-
al levels from 10 % to 100 % and 2700 K to 6500 K (warm white to cold white).
This will enable you to perfectly adapt the light to the current lighting conditions
and demands of your workplace.
• You control the light via 2 sensor lines by a simple touch.
• To get the light exactly where you need it, the lamp arm is mounted via a
hinge at the support arm. It may be folded up by approx. 180°. Additionally,
you can rotate the lamp arm about the axis. Therefore, you can direct the light in
all directions and badly illuminated corners and spots of your workplace are old
hats.
• For your convenience, the light features a memory function: the light will keep
your recent setting in memory even when unplugged at the end of the day. When
switched ON again, the light will start with this setting.
POWER OUTPUT FUNCTIONS
You may use the light as a 5 V power supply for various electronic devices, espe-
cially for recharging the batteries of mobile phones. For this, 2 USB ports and a
Qi wireless port are provided within the base of the light.
• The USB ports of the light adjust the current automatically, according to the
requirements of the devices connected.
• The ports (USB and/or Qi wireless port) may be used simultaneously as you
like.
• When used separately, each port can provide a maximum current of 2 A.
• With the USB ports used simultaneously, the maximum output current of the
ports in use will be reduced accordingly to give a total maximum current of 2 A.
34