Grundig GWN 36432 Bedienungsanleitung Seite 72

Cleaning the water intake filters
There is a filter at the end of each
water intake valve at the rear of the
machine and also at the end of each
water intake hose where they are
connected to the tap. These filters
prevent foreign substances and dirt
in the water to enter the washing
machine. Filters should be cleaned as
they do get dirty.
• Close the taps.
• Remove the nuts of the water
intake hoses to access the filters
on the water intake valves. Clean
them with an appropriate brush.
If the filters are too dirty, take
them out by means of pliers and
clean them.
• Take out the filters on the flat
ends of the water intake hoses
together with the gaskets and
clean thoroughly under running
water.
• Replace the gaskets and filters
carefully in their places and
tighten the hose nuts by hand.
72
Draining remaining water and
cleaning the pump filter
The filter system in your machine
prevents solid items such as buttons,
coins and fabric fibers clogging the
pump impeller during discharge of
washing water. Thus, the water will be
discharged without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the
pump filter is clogged. Filter must be
cleaned whenever it is clogged or in
every 3 months. Water must be drained
off first to clean the pump filter.
In addition, prior to transporting the
machine (e.g., when moving to another
house) and in case of freezing of the
water, water may have to be drained
completely.
A
WARNING:
left in the pump filter may damage
your machine or may cause noise
problem.
A
WARNING:
in use, turn the tap off, detach the
supply hose and drain the water
inside the machine against any
freezing possibility in the region of
installation.
A
WARNING:
the supply hose tap of the product.
In order to clean the dirty filter and
discharge the water:
• Unplug the machine to cut off the
supply power.
A
WARNING:
water inside the machine may rise
up to 90 ºC. To avoid burning risk,
clean the filter after the water in
the machine cools down.
Foreign substances
If the product is not
After each use close
Temperature of the