Grundig GWN 36432 Bedienungsanleitung Seite 64

• Selbstreinigung (MachineCare)
Use regularly (once in every 1-2
months) to clean the drum and
provide the required hygiene. Apply
this procedure without any laundry in
the product. To obtain better results,
put powder limescale remover for
washing machines into the detergent
compartment "2". When the
programme is over, leave the loading
door ajar so that the inside of the
machine gets dry.
C
This is a maintenance programme,
not a washing programme.
Do not run the programme when
there is something in the machine.
If you try to do so, the machine
detects that there is a load inside
and aborts the programme.
Special programmes
For specific applications, select any of
the following programmes.
• Spülen (Rinsing)
Use when you want to rinse or starch
separately.
• Schleudern+Abpumpen
(Spin+Pump)
Use this programme to discharge the
water in the machine.
Temperature selection
Whenever a new programme
is selected, the recommended
temperature for the selected
programme appears on the
temperature indicator.
To decrease the temperature, press
the Temperature Adjustment button.
Temperature will decrease gradually.
C
If the programme has not reached
the heating step yet, you can
change the temperature without
switching the machine to Pause
mode.
64
Selecting the spin speed
Whenever a new programme is
selected, the recommended spin
speed of the selected programme is
displayed on the Spin Speed indicator.
To decrease the spin speed, press
the Spin Speed Adjustment button.
Spin speed decreases gradually.
Then, depending on the model of the
product, "Rinse Hold" and "No Spin"
options appear on the display. See
"Auxiliary function selection" section
for explanations of these options.
Rinse Hold
If you are not going to unload your
clothes immediately after the
programme completes, you can use
Rinse Hold function to keep your
laundry in the final rinsing water in
order to prevent them from getting
wrinkled when there is no water in
the machine. Press Start / Pause
button after this process if you want to
drain the water without spinning your
laundry. Programme will resume and
complete after draining the water.
If you want to spin the laundry held in
water, adjust the Spin Speed and press
Start / Pause button.
Program resumes. Water is drained,
laundry is spun and the programme is
completed.
C
If the programme has not reached
the spinning step yet, you can
change the speed without switching
the machine to Pause mode.