Grundig GWN 36432 Bedienungsanleitung Seite 52

Installation
Refer to the nearest Authorised
Service Agent for installation of the
product. To make the product ready
for use, review the information in the
user manual and make sure that the
electricity, tap water supply and water
drainage systems are appropriate
before calling the Authorized Service
Agent. If they are not, call a qualified
technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
B
WARNING:
electrical connections of the
product must be carried out by
the Authorized Service Agent.
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorized persons.
A
WARNING:
visually check if the product has
any defects on it. If so, do not have
it installed. Damaged products
cause risks for your safety.
C
Make sure that the water inlet
and discharge hoses as well as
the power cable are not folded,
pinched or crushed while pushing
the product into its place after
installation or cleaning procedures.
Appropriate installation location
• Place the machine on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
• Total weight of the washing
machine and the dryer -with full
load- when they are placed on top
of each other reaches to approx.
180 kilograms. Place the product
on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the
power cable.
• Do not install the product at
places where temperature may
fall below 0ºC.
• Leaving a gap at the sides of the
machine is suggested to reduce
vibration and noise
52
Installation and
Prior to installation,
• Do not place heat sources such
as Hobs, Irons, Ovens, etc. on the
washing machine and do not use
them on the product.
Removing packaging reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove
the packaging reinforcement by pulling
the ribbon.
Removing the transportation locks
A
WARNING:
transportation locks before taking
out the packaging reinforcement.
A
WARNING:
transportation safety bolts before
operating the washing machine!
Otherwise, the product will be
damaged.
• Loosen all the bolts with a
suitable spanner until they rotate
freely.
Do not remove the
Remove the