Bamo NivOil Bedienungsanleitung Seite 20

TECHNICAL DATA (continuation)
High Level Probe (NivOil HPS)
Exclusively for connection to the sensor supply unit (NivOil CU)!
Material sensor
Cable
Cable colour
Dimensions
Protection
Measuring principle
Ambient temperature
EU Type Examination Certificate BVS 09 ATEX E 021 X
Ex-maximum values
Maximum input voltage Ui
Maximum input current Ii
Maximum input power Pi
Maximum internal capacity Ci
Maximum internal inductance Li
Ex marking
Interconnection
Note!
Use only in stagnant or slow-flowing media.
Strong mechanical impacts on the probe housing must be avoided during installation, maintenance work and operation.
Clean only with a damp cloth, avoid electrostatic discharges!
Special conditions for safe use
The connection line of the high level probe (NivOil HPS) must be routed through the separation between areas with category 1G requirements
and less hazardous areas in such a way that protection class IP67 in accordance with EN 60529 is guaranteed.
The high level probe (NivOil HPS) and connection cable may only be used in areas where there is no risk of electrostatic discharging.
The technical information on the use of the high level probe (NivOil HPS)
- in connection with aggressive/corrosive media
- with regard to protection against impact
- with regard to the flow velocity of the media
- Cleaning
are to be observed.
EN
M-531.01-EN-AK du 30-06-2023 - Manufacturer : BAMO IER - Pirnaer Straße 24, D-68309 Mannheim - Germany (Translated document)
PVC
Fitted with 10m oil/petrol-resistant cable as standard (2x1mm²)
Other cable lengths on request,
Maximum permissible cable length: 300m
[C ≤ 200nF/km and L ≤ 1mH/km]
blue
approx. 145x90x25mm
IP68
Ultrasound
-20°C...+60°C
17.9V DC
157mA
695mW
60nF
(no mixed parameters)
70μH/m
(no mixed parameters)
㐀 II 1G Ex ia IIB T4 Ga
(intrinsically safe electrical equipment)
Sensor supply unit (NivOil CU) with high level probe (NivOil HPS)
·