AEG EEB331010M Benutzerinformation Seite 28

Step 7 Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the above steps
in the opposite sequence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of the door
may overheat.
11.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
28 ENGLISH
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
12.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Step 3
Put a cloth on the bottom of the cav‐
ity.