Safety Instructions For Operation - Cloer 6731 Bedienungsanleitung

Dear Customer,
we wish you a lot of pleasure with your new
Cloer Barbecue Grill 6731. By buying the new
grill you have decided on a quality product
combining technology, high functionality and
modern design.
Your new Cloer Barbecue Grill will make your
barbecue evening a carefree event. Enjoy your
meal!
Your company Cloer
Before using the first time
·
Remove all packaging parts and, if applicable,
stickers, not the identification plate.
·
Before using the first time, clean the grilling
surface by means of a soft cloth.

Safety instructions for operation

The appliance meets the
requirements of the applicable
EC directives.
The appliance is intended for in
door use only.
ATTENTioN!
Grilling surface as well as lid get
extremely hot in operation. There
is the danger of burns and fire!
only touch the lid at the heat-
isolated handles.
·
Use Barbecue Grill exclusively with the delivered
connector plugs.
·
Never cover the grilling surface with aluminium
foil.
·
Do not put saucepans or pans on it, as the heat
development can cause deterioration of the
non-stick coating.
·
Never put baking paper and inflammable
materials on the grilling surface. The immense
heat can cause fire!
·
Never let the grill unattended while in
operation.
·
Keep it well away from swimming/paddling
pools, sprinklers, and hoses.
·
Do not place the grill next to inflammable
objects.
·
Route the cable so it doesn't overhang, and can't
be tripped over or caught.
·
Use oven gloves if necessary.
·
Never use the grill without the drip tray.
ATTENTioN!
Even at the lowest setting of the
thermostat (level 1 or lower) the
appliance is already in operation.
Unplug the power plug to switch
off the appliance completely.
·
During the very first heating up the appliance
can cause slight smoke. After some minutes,
however, smoking will stop again.
ATTENTioN!
Do not use charcoal or similar
combustibles as well as so-called
grill lighters for the Barbecue Grill!
Setup
3
·
Turn the lower tube (= the tube without grooves
and plastic stopper) into the middle of the base
clockwise with the thread down until it is firmly
seated (step 1).
·
Then turn the upper tube clockwise into the lower
tube. The grooves must point up (step 2).
·
Extend the support grips until they latch and push
the support onto the tube construction from the
top until it is seated securely on the two plastic
stoppers with its protrusions (step 3).
·
Now put the plastic housing (with the grease
collection drawer to the front) onto the top of the
holder (step 4) and push the enclosed pin through
the housing and tube below the plastic housing
(step 4.1).
·
ATTENTioN: Never use the grill without the
grease collection tray and ensure that it is
latched.
·
Now put the grill plate onto the housing (step 5).
·
The socket must point to the right.
·
Now put the lid onto the grill with the grip facing
forwards.
·
information: The lid can be opened and pushed
into two holders at the rear of the griddle.
EN
6
5
4
4.1
2
1
9