Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to run a wash cycle
52
4.Press the START/PAUSE (START/PAUZE) button again to continue the cycle.
Modifying the programme in progress
Before making any changes to the current programme, you need to pause the
washing machine by pressing the START/PAUSE (START/PAUZE) pushbutton.
If the modification is not possible, "Err" flashes in the display window and the
START/PAUSE (START/PAUZE) button flashes in yellow for several seconds. If
you still decide to change the programme, you must cancel the current
programme (see below).
Cancelling the programme
If you want to cancel the programme, turn the programme selector to the
STOP (AUS)
End of the programme
The washing machine stops automatically ; the START/PAUSE (START/PAUZE)
pushbutton goes out and "0" flashes on the display. The locking mechanism
"snaps" twice to indicate that the lid is open. The LID (DECKEL) indicator lights
off.
1.Position the programme dial on the STOP (AUS)
chine is switched off.
2.Remove washing.
3.Unplug and close water inlet tap.
4.Check that the drum is in fact empty: if any textiles remain inside, they could
be damaged (shrunk) during the next wash or the colour could run onto other
pieces of laundry.
We recommend leaving the lid and drum open after use to ventilate the water
tank.
Standby mode
If the appliance is on but no commands are selected for 10 min before or after
a cycle, it goes into standby mode. The screen light goes out and START/
PAUSE (START/PAUZE) flashes slowly.
To exit standby mode, simply press any pushbutton or turn the programme
selector.
position.
position : the washing ma-
Werbung
