Simplek Pro Bedienungsanleitung Seite 21

Cancel calibration: If the e-bike is ridden in calibration mode, the calibration is aborted and the sIMPLEk jumps
back to 1:1 mode. In this case, no calibration took place.
E-bikes without a display: In this case, no calibration is necessary. When using the module for the first time,
you must inform the module that there is no display by driving off immediately or spinning the rear wheel.
Setting the speed limit for motor support: The speed limit can be adjusted by calibrating at a speed other than
10.0 . The table below shows the calibration values and the associated speed limits. It should be taken into account
that the support starts to be throttled from the speed limit and ends approx. 6 later.