2.3. Installation example Active Line (Plus) from 2018 onwards and
Performance-Line from 2020 onwards:
Tools needed:
•
Torx 20 socket wrench
•
Optional: flat nose pliers
Remove the two torx screws with the socket wrench (image 9). Now the engine cover can be removed. If necessary,
use flat-nosed pliers to pull out the speed sensor plug (image 10).
Now connect the plug of the sIMPLEk to the position of the previously unplugged speed sensor. The speed sensor is
then connected to the connector of the sIMPLEk (image 8). The polarity does not need to be considered.
image 9
image 10